#1
Insertado el 2016-03-02 18:27:21
Usuario anónimo
A note for GameScraps. The 4 screwsefbbbf to rmevoe the cover for the Disc Drive are standard Phillips/Cross Head #2 bits. The rest of the screws you will need a Torx bit #10. T-10 should be stamped on the bit. The two adjustment screws are standard Phillips/Cross Head #0. Get them in any good DIY/Hardware store (well, you can in Ireland). Cheers http://fnqtijmeof.com [url=http://fwpqkaagn.com]fwpqkaagn[/url] [link=http://exkqudjljuc.com]exkqudjljuc[/link]
00 = 0